Jump to content
Light-O-Rama Forums

show running....but no lights....


rednosetbird

Recommended Posts

rednosetbird wrote:

The red light is blinking

ok you need to go to the hardware utility right click on the bulb, set your max unit id to five,under auto configure port hit refresh,once it finds the port the refesh the network and it should find three units
Link to comment
Share on other sites

Ill give that a try.Have to run out now for dinner with wife and kids.But ill keep you posted what happens tonight.Thank you for your help!This can be so furstrating!!!!!! But I still love it.Thanks again

Link to comment
Share on other sites

Guest wbottomley

If the light is blinking while the show is running, then you have a bad cable somewhere. They should be on solid.

Setting the max units in the HU will not fix the problem. What level of license and how many controllers do you have?

Link to comment
Share on other sites

wbottomley wrote:

If the light is blinking while the show is running, then you have a bad cable somewhere. They should be on solid.

Setting the max units in the HU will not fix the problem. What level of license and how many controllers do you have?

I knew that was not the fix,just wanted to see if the hu would pick up the controllers,so setting the hu to max just speeds up the process,I guess you forgot what it was like having less than 100 controllers:)
Link to comment
Share on other sites

Guest wbottomley

james campbell wrote:

wbottomley wrote:
If the light is blinking while the show is running, then you have a bad cable somewhere. They should be on solid.

Setting the max units in the HU will not fix the problem. What level of license and how many controllers do you have?

I knew that was not the fix,just wanted to see if the hu would pick up the controllers,so setting the hu to max just speeds up the process,I guess you forgot what it was like having less than 100 controllers:)



LOL. I have to quit answer posts when I'm beaten like an egg. :D

I did that with one unit and was unsuccessful. I'll have to replace those rotary dials next year.
Link to comment
Share on other sites

Still at a loss. Changed settings to 5,Hit the auto configure port told me to only have one controller hooked up so I did so and the light came on solid and it found port.hit refresh again found box,then tried pluging in other controller box and both of them started to flash.At a loss again.I have a total of 3 controllers.

Link to comment
Share on other sites

if you are getting a solid light on you controller then the port is ok, do you have all the controllers daisy chained or are you just checking them one at a time?

Link to comment
Share on other sites

james campbell wrote:

if you are getting a solid light on you controller then the port is ok, do you have all the controllers daisy chained or are you just checking them one at a time?


Thay are daisy changed..tested the cables with a cad 5 tester and thay are fine.I can only get a solid light on when only 1 of them are conected.I would like to cheek them all.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...