testraub Posted November 12, 2011 Share Posted November 12, 2011 2nd year No problems last year with S2. New to S3, but setup pretty much the same (added channels) lights are NOT turning off after each sequence. Any ideas? And yes, have re-vamped the sequences, re-done the schedule and show editor.Tom Straub Link to comment Share on other sites More sharing options...
Paul Roberson Posted November 12, 2011 Share Posted November 12, 2011 Do you have "turn used lights off at the end of each sequence" checked in the show builder? Attached files Link to comment Share on other sites More sharing options...
testraub Posted November 12, 2011 Author Share Posted November 12, 2011 Yup And re-saved the show too. Link to comment Share on other sites More sharing options...
Dave Pursel Posted November 12, 2011 Share Posted November 12, 2011 My thoughts on the problem. If your using show builder the assumption is your using a show director with a sd card. Just a idea you might want to try. In order to be sure you have the new show loaded with the version "turn used lights off". Erase all files from your card to be sure your getting a fresh reload. Link to comment Share on other sites More sharing options...
bob Posted November 14, 2011 Share Posted November 14, 2011 Note that there are a few different "turn used lights off at the end of each sequence" checkboxes. Several sections of the show have them, and they each affect only the section of the show that they're in. Link to comment Share on other sites More sharing options...
Recommended Posts