Guest guest Posted November 25, 2006 Share Posted November 25, 2006 I am using the new version of the Hardware Utility. It will find the controller units in my display, with the exception of the the 2 controllers I have programmed with standalone animation. Is there a way to make the Hardware Utility see these controllers, or is there a way to make the controllers forget they are standalone so that I can access them again. Link to comment Share on other sites More sharing options...
Guest guest Posted November 26, 2006 Share Posted November 26, 2006 Reset the controllers: Power off, set unit ID to 00, power on for 5 seconds. Then power off and sent the unit ID back to the original version.A couple of other things, Standalone controllers should not be in the network, they can interfer with the other controllers. Standalone does mean that it is not connected to the PC. Link to comment Share on other sites More sharing options...
Recommended Posts