Guest guest Posted November 25, 2006 Share Posted November 25, 2006 Dan - I just hooked up my easy light linkers, and cannot get them to run the show. It doesn't seem to be communicating. The red light is flashing in the linker, but the led2 light that says it should flash when transmitting never comes on. Any help is appreciated. Link to comment Share on other sites More sharing options...
Guest guest Posted November 25, 2006 Share Posted November 25, 2006 I don't own an ELL set, so I'm going off of what I've seen posted.1) Make sure you are running the latest firmware.2) Make sure the cable connection from the computer to the ELL is good.After that ... others are going to have to chime in. Link to comment Share on other sites More sharing options...
Guest guest Posted November 25, 2006 Share Posted November 25, 2006 Problem solved. I needed to change the com port that the show uses. Link to comment Share on other sites More sharing options...
Recommended Posts