aurickle Posted October 15, 2011 Share Posted October 15, 2011 I have two CCR's with the same sequences programmed to each. The second one in the series, however, is acting funky while playing. The colors are supposed to be all orange and red, but I'm getting a lot of green in there and sometimes the pixels stay on when they shouldn't.I have already tried resetting the CCR. Its test pattern played fine.Any thoughts?The only thing I can think of (short of a defect, which doesn't seem the case if the test was fine) is simply that I have too much going on. I wouldn't have expected that, since I have just the two CCR's and about 60 other channels. But I can't think of anything else.Do you think it might help if I were to delete the second CCR from my sequence and instead assign the same unit ID to both ribbons? Link to comment Share on other sites More sharing options...
Guest wbottomley Posted October 15, 2011 Share Posted October 15, 2011 Check the data cable to ensure a good connection is made. Link to comment Share on other sites More sharing options...
Dennis Cherry Posted October 15, 2011 Share Posted October 15, 2011 Also swap the 2 ribbons and see if the errors move also.Leave the controllers as is only swap the ribbons Link to comment Share on other sites More sharing options...
aurickle Posted October 16, 2011 Author Share Posted October 16, 2011 I checked the data cable. No problem. Also, the two 16-channel controllers after it in the series work without issue, so I didn't expect to find anything wrong there.Switching the ribbons between the controllers moved the problem to the other ribbon. Good idea, Dennis!I went into the hardware utility to make sure that both ribbons were configured the same. They were. But something interesting happened: The problem unit first showed up as "Unknown Device". Refreshing again showed it correctly as CCR with ID 7. At that point I remembered the same thing happening the day before when I was doing my final set up.I have tried flashing the firmware, even though it was already at the most current version. The problem was not resolved.Does anyone have suggestions at this point? Or does it sound like this particular controller is bad? Link to comment Share on other sites More sharing options...
aurickle Posted October 18, 2011 Author Share Posted October 18, 2011 At this point I have also tried running just the one ribbon with everything else disconnected from the network. The exact problem still happens.I have also carefully gone back through the channel configuration to ensure that no channels are misnumbered. Link to comment Share on other sites More sharing options...
Dennis Cherry Posted October 18, 2011 Share Posted October 18, 2011 aurickle wrote: At this point I have also tried running just the one ribbon with everything else disconnected from the network. The exact problem still happens.I have also carefully gone back through the channel configuration to ensure that no channels are misnumbered.Time to call LOR support. Link to comment Share on other sites More sharing options...
aurickle Posted October 18, 2011 Author Share Posted October 18, 2011 Thanks. I appreciate the advice. Link to comment Share on other sites More sharing options...
Recommended Posts