Guest guest Posted November 23, 2006 Share Posted November 23, 2006 Probably one for Dan or someone else fairly familiar with the circuit.Noted that the pin connectors on the controllers have a pin marked 'LED' (BTW: the layout of the connector has changed on the V6 boards but the User's Guide shipped with the controllers still show the earlier configuration) and I was wondering if the output on this pin can drive an additional LED that I could mount on the enclosure cover to check board status without opening up the enclosure.And if it will support it, is the other side of the LED connected to Ground, +5, or ??? and would it need a resistor?Thanks!-jim Link to comment Share on other sites More sharing options...
Recommended Posts