Jump to content

Controllers dont show up in hardware utility(resolved)


Guest guest
 Share

Recommended Posts

Ok so I have 2 of my 5 boxes set up. I have a solid LED on both boards, and when I search the network in the hardware utility it only finds one controller. I have the first one set to 01 01, and the second one set to 01 02. When I test it it shimmers or twinkles a tree on each controller.

Any ideas?

Link to comment
Share on other sites

logan_moore wrote:

Well this problem is fixed, however is there any way to split from one box out into two other boxes?

Thanks,
Logan


You mean...


3
/
1---

2

?
Link to comment
Share on other sites

Simple answer is no, they're designed to go in a straight line.

In the past, Dan said it might work if one of the legs of the "Y" created was very short. But I don't personally think it's worth it. I have a controler that's out in the middle of nowhere that I have to run two cables side by side to get to and back. It would be nice to be able to 'Y" it but this way works...

-Tim

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...