pyromill Posted September 1, 2011 Share Posted September 1, 2011 Ok so here it goes.. I have tried to use the input trigger on my CMB16 dc controller with the hardware utility test for input triggers it says "Controller is not responding" output test works just fine.. and a stand alone sequence on it works just fine with using that same input trigger. Why does the software not see it ? firmware version 1.30 software version of both lor and hardware utility are both 2.8.12 i tested one of my CTB16's and the trigger polling works in the hardware utility. Any idea's anyone ? Link to comment Share on other sites More sharing options...
-klb- Posted September 1, 2011 Share Posted September 1, 2011 I don't think the CMB16D trigger is usable as a remote trigger like the inputs on the rest of the boards. From the user guide:[align=left]JP3/PGM Header[/align][align=left]The figure on the next page shows how to connect a push button switch to the circuit board header to start a standalone sequence.Currently, only ‘Input 1’ is supported. The standalone sequence in the CMB16D will start when the push button is pressed. If you use a toggle switch, the sequence will run until the switch it turned off. The sequence always runs to completion, even if the toggle switch is turned off in the middle. Only use the Input 1, +5V, +10V and GRND pins.[/align] Link to comment Share on other sites More sharing options...
Recommended Posts