Jump to content

I triped over the data input, hurt my board


Guest guest
 Share

Recommended Posts

Well like the title says. I triped over the cat5 cable and it pulled the input in the middle down (bent) it wasnt working, I pushed on it and its working so i didn't rip it out, but it is still bent down. Now what?

I was testing a mega tree and it was dark.... At least its not the first show

Thanks Jordan

Link to comment
Share on other sites

you got lucky, if it still works. I have a bad board, and i didn't do any thing to it.

or as i like to say, i have a $500 flashing red LED

Link to comment
Share on other sites

ndiaz wrote:

you got lucky, if it still works. I have a bad board, and i didn't do any thing to it.

or as i like to say, i have a $500 flashing red LED



Dan wont look at it?

I have yet to pull it in and take a peak at it. Should it just push back in? The fact that it stoped working is what bothers me.

Thanks Jordan


Fixed it, It didnt break the tabs off just pulled them out. shwooo:waycool:
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...