ecool365 Posted December 6, 2010 Share Posted December 6, 2010 I am not sure how but both of my 16 pc controllers are doing the same thing. It said one thing I read to change controller id in controllers but mine do not have ajustments. Please help. Because now my hardware utility only shows one controller found but operates both together. Link to comment Share on other sites More sharing options...
Don Posted December 6, 2010 Share Posted December 6, 2010 Since you have no dials, it means you have the CTB-PC version of controller.Connect *one* controller to your computer and set the channel via the Hardware Utility. That will set the address of the controller. Link to comment Share on other sites More sharing options...
George Simmons Posted December 6, 2010 Share Posted December 6, 2010 When the controllers leave LOR they are all set to unit ID #1. Not only do you have to change the one you wish to use as controller 2 to that ID number, but you need to make sure your channels are properly assigned to the two controllers also. Good luck. Link to comment Share on other sites More sharing options...
Recommended Posts