loren Posted December 5, 2010 Share Posted December 5, 2010 Hardware doesn't find two of the controllers when I hit the refresh button, it only recognizes the one controller, I have the first connected by cat 5 and then jumper going to unit two and then jump to unit three.. Anybody? Loren Link to comment Share on other sites More sharing options...
Don Posted December 5, 2010 Share Posted December 5, 2010 What version of controller? Did you assign them an address of (I would presume) 02 and 03?Sounds like the addresses have not been set. As such, it can't "see" the other controllers because they are most likely all "01" Link to comment Share on other sites More sharing options...
loren Posted December 5, 2010 Author Share Posted December 5, 2010 Don wrote: What version of controller? Did you assign them an address of (I would presume) 02 and 03?Sounds like the addresses have not been set. As such, it can't "see" the other controllers because they are most likely all "01"By version you mean LOR160xW? And the instruction booklet doesn't really tell me how to set the other addresses, can you point me in the right direction? Link to comment Share on other sites More sharing options...
Don Posted December 5, 2010 Share Posted December 5, 2010 loren wrote: By version you mean LOR160xW? And the instruction booklet doesn't really tell me how to set the other addresses, can you point me in the right direction?Page 17 - "Assigning a Unit ID" Link to comment Share on other sites More sharing options...
HowardShank Posted December 5, 2010 Share Posted December 5, 2010 loren wrote: Don wrote: What version of controller? Did you assign them an address of (I would presume) 02 and 03?Sounds like the addresses have not been set. As such, it can't "see" the other controllers because they are most likely all "01"By version you mean LOR160xW? And the instruction booklet doesn't really tell me how to set the other addresses, can you point me in the right direction?The 160xW are set via small rotator switches located in the controller. Attached files Link to comment Share on other sites More sharing options...
loren Posted December 5, 2010 Author Share Posted December 5, 2010 loren wrote: Hardware doesn't find two of the controllers when I hit the refresh button, it only recognizes the one controller, I have the first connected by cat 5 and then jumper going to unit two and then jump to unit three.. Anybody? LorenHow do I assign addresses of the switches on contoller two, three, and four? Thanks in advance. Loren Link to comment Share on other sites More sharing options...
Don Posted December 5, 2010 Share Posted December 5, 2010 To set the Unit ID to ’01,’ the left rotary switch would be set to ‘0’ and the right rotary switch would be set to ‘1.’To set the Unit ID to ’02,’ the left rotary switch would be set to ‘0’ and the right rotary switch would be set to ‘2.’To set the Unit ID to ’03,’ the left rotary switch would be set to ‘0’ and the right rotary switch would be set to ‘3.’(From page 17-18 of the manual.) Link to comment Share on other sites More sharing options...
loren Posted December 6, 2010 Author Share Posted December 6, 2010 Thanks a bunch.....got it to recognize each of the controllers, now on with the next step. Again thanks loren Link to comment Share on other sites More sharing options...
Recommended Posts