Jump to content
Light-O-Rama Forums

one controller not working


Ralph Priest

Recommended Posts

I have 1 16 channel controller and 2 8 channel controllers. in the hardware utility when i hit refresh to see my 3 controllers it only see's 2 of my controllers. The weird thing is it sees number 1 and 3 but not 2. The selectors are set at 1,2,and3 and I can only see 1 and 3. The red led light is blinking so there is power. Please help

Link to comment
Share on other sites

Are they wired in order (e.g. computer -> 1 -> 2 -> 3)?

And just to verify, the LED for #2 is flashing, but not #1 and #3?

That's an unusual situation. What model is #2?

Link to comment
Share on other sites

Hey Tim,thanks for your response to my question. I believe my friend found the problem: I had the crawlspace cleaned-up and sealed last summer and apparently the "workers" pulled the second CAT5 cable,laid plastic over it and stapled the cable to the ground.That was controller #2 which,of course,was linked both to the main box and the third as well. So--I'll run a test show tonight and hope for the best.It never ceases to confound me that in this rotten economy the work ethic of most contractors( that I have dealings with)is still patheticly lacking.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...