gatorfan Posted November 30, 2010 Share Posted November 30, 2010 This is my first time using LOR. I built a show using EasyShowBuilder and it ran fine last night. Today I used Show editor to remove some sequences and add new ones. Tonight, my show runs once and stops. I don't know what I did. I want my 7 sequences to run continuously between 6 and 10pm. Can anyone help me?Thanks Link to comment Share on other sites More sharing options...
Don Posted November 30, 2010 Share Posted November 30, 2010 From within the LOR Control Panel ....Click on Status. What does it say the software should be doing? Does it show any error messages?Click on Schedule Editor. Scroll down. Are shows scheduled to run at this time? Link to comment Share on other sites More sharing options...
gatorfan Posted November 30, 2010 Author Share Posted November 30, 2010 The status says enabled. I checked the scheduler and the show is listed for the timeframes I indicated. It just stops after the last sequence instead of starting over.Thanks! Link to comment Share on other sites More sharing options...
Don Posted November 30, 2010 Share Posted November 30, 2010 If you enable the shows, and leave the Status Window up, what does it say? Does it indicate that it's playing a sequence, when in fact it's not?For shows to be scheduled/enabled and not playing would be very odd. Link to comment Share on other sites More sharing options...
gatorfan Posted November 30, 2010 Author Share Posted November 30, 2010 Yes - that is exactly what is happening. I ust rebooted the PC and the show is running - we'll see if it keeps playing until 10pm - I have my fingers crossed!Thanks! Link to comment Share on other sites More sharing options...
gatorfan Posted December 1, 2010 Author Share Posted December 1, 2010 The show still stops-I will redo everything and start over. Thanks. Link to comment Share on other sites More sharing options...
Recommended Posts