Channels work in hardware console, but not in sequence editor?

[nmessick]

I have a controller that responds just fine in the hardware console, but does not respond to commands in the sequence editor. I have no idea whats up, the network is set right... but beyond this there is nothing else to change. Any idea whats up?

[Brian Mitchell]

In the sequencer, go under Edit, Preferences, Network Preferences and make sure it is set to the same comm port as the Hardware Utility.

Also make sure Control Lights is checked in the Play menu.




Edited for spelling.

[nmessick]

I'll check, but there are other controllers on the network that are working fine.

[Brian Mitchell]

Well...that's a horse of a different color.

Double check your channel config to make sure the controller matches where you defined it.

I once did a dyslexic thing and set 09 as 90. That was fun to find since the HU did not look that high.