Jump to content
Light-O-Rama Forums

Playing a sequence live

Paul D

Recommended Posts

Only one of the following can control the lights at any given time:

(1) The Sequence Editor
(2) The Hardware Utility
(3) The Show Player

So, if you have the Hardware Utility running, close it, and if you have shows enabled, disable them. I believe that you will then have to close the Sequence Editor and start it up again in order for it to retry.

Another thing to check is that you have your network configuration set up properly. Check the Sequence Editor's "Edit / Preferences / Network Preferences" and make sure that you have the appropriate comm port defined as one of your networks, and that you do not have any inappropriate comm ports defined as any of your networks.

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Create New...