Testing lights

[ShortysLandscaping]

Is there a way to just turn all your lights on, without having to set a sequence for it?

[TJ Hvasta]

Using the Hardware Utility, after you Refresh and the HU finds the controller, in the Test Unit's Operation, click ALL button, then just below that in Chase Sequence , click ON.. Other test to do is just below Chase, in Light Mode window, click Steady, ON at 100%

If you have more than one controller, you have to choose Unit #, then do the above for each unit.

One quick time-saving item.. if you only have a couple.. (less than 10 controllers), click Max Unit ID Change button, adjust the slider to the number of controllers you have (or really one more than you have).. saves a LOT of time when the HU is searching for the controllers to address.

[Brian Mitchell]

Yes you have to make a sequence to turn everything on.

Super easy though.

Create an animation sequence with no timings, one minute long.

Import your configuration.

Highlight all your channels. press N, done.

I use this when I am testing the show and want to turn on different section that I want to repair or test. I just quickly turn sections on or off and let it play. I turn on loop at end also.




This is if you have more than one controller...otherwise...see above post.