wglyons Posted October 3, 2010 Share Posted October 3, 2010 I have a bunch of c9's to go on the roof. I want to set the maximum intensity to 50% to cut down on the current draw, and therefore, the number of channels I will need to use for those bulbs. This will allow me to go from using three channels down to two. My question is, is there a way to set the max intensity to 50% for those channels on an entire sequence, or do I have to manually go back through and change each effect manually?Thanks,Greg Link to comment Share on other sites More sharing options...
Tim Herberger Posted October 3, 2010 Share Posted October 3, 2010 Unfortunately, right now, adjusting all your sequences , is the only way do set maximum intensity on just a few channels.There is supposed to be a (yet to be released?) new hardware utility with the ability to set dimming properties on a per channel basis, at the controller level. I haven't heard any news about it and if it will be out in time for this years shows... Link to comment Share on other sites More sharing options...
Recommended Posts