Mark Belgen Posted December 16, 2009 Share Posted December 16, 2009 The 1st 3 LED's on my CCR flash red to various other channels when there is no programing for the channels that the CCR is configured to. The channels that it flashes to varies and is not consistent. I have checked and there is no conflict in LOR box# and channel# configuration. Very odd and very annoying.What is causing this? Link to comment Share on other sites More sharing options...
ItsMeBobO Posted December 16, 2009 Share Posted December 16, 2009 The first pixel (3 LEDs) is the only one flashing. This is your CCR channels 1 2 3 with resolution set to 50. I have not seen this behavior on mine.Can you post or send me a sequence which is doing this ? I can run it on mine and see if behavior is the same. Link to comment Share on other sites More sharing options...
Steven Posted December 21, 2009 Share Posted December 21, 2009 I have seen this happen with my units, which are not CCR. The diagnosis was that it was caused by noise on the LOR network. I fixed the problem by installing terminators on the ends of the network. Link to comment Share on other sites More sharing options...
George Simmons Posted December 21, 2009 Share Posted December 21, 2009 Steven,Please define what you mean by "terminator"?Thanks. Link to comment Share on other sites More sharing options...
Steven Posted December 21, 2009 Share Posted December 21, 2009 See my post here. It's a 120Ω resistor at the end of the LOR network. Link to comment Share on other sites More sharing options...
Recommended Posts