Jump to content
Light-O-Rama Forums
Sign in to follow this  
Blair Melanson

lor board

Recommended Posts

i have 4 arches 7 channels to each arch using 28 channels with 4 left over number 9 channel is dead can i delete channel number 9 and take channel number 13 and put it in the place of number 9 will it work ok in the sequence thank you Blair

Share this post


Link to post
Share on other sites

Yes, just change that channel in the sequence editor from 9 (or whatever) to 13, and then move the plug over to 13 and you should be good to go.

Share this post


Link to post
Share on other sites

Just to make your work sheet in the sequence editor flow better, you can move channels up or down. Just do a right-click on the ch9 button and delete it from the popup menu, then go to ch13 and right-click to open the menu again and do this several times to move it up below ch8 where ch9 was. The unit and channel settings will not change, just the location of the buttons on the left side of the screen.

Then from the EDIT menu, EXPORT your new channel configuration and then import it into all other sequences. Fast and easy fix.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×
×
  • Create New...