Blair Melanson Posted November 25, 2009 Share Posted November 25, 2009 i have 4 arches 7 channels to each arch using 28 channels with 4 left over number 9 channel is dead can i delete channel number 9 and take channel number 13 and put it in the place of number 9 will it work ok in the sequence thank you Blair Link to comment Share on other sites More sharing options...
Jeff Sand Posted November 25, 2009 Share Posted November 25, 2009 Yes, just change that channel in the sequence editor from 9 (or whatever) to 13, and then move the plug over to 13 and you should be good to go. Link to comment Share on other sites More sharing options...
George Simmons Posted November 25, 2009 Share Posted November 25, 2009 Be sure that the change makes its way into all of your sequences. Link to comment Share on other sites More sharing options...
George Cotton Posted November 25, 2009 Share Posted November 25, 2009 Just to make your work sheet in the sequence editor flow better, you can move channels up or down. Just do a right-click on the ch9 button and delete it from the popup menu, then go to ch13 and right-click to open the menu again and do this several times to move it up below ch8 where ch9 was. The unit and channel settings will not change, just the location of the buttons on the left side of the screen.Then from the EDIT menu, EXPORT your new channel configuration and then import it into all other sequences. Fast and easy fix. Link to comment Share on other sites More sharing options...
Blair Melanson Posted November 26, 2009 Author Share Posted November 26, 2009 Gentlemen thank you for your reply Blair Link to comment Share on other sites More sharing options...
Recommended Posts