Rusty Posted October 16, 2018 Share Posted October 16, 2018 I just received 4 - 50 watt floods and they won't play in sequence editor. These are the only props in the sequence. They work in HU. They are set up as dumb RGB running on enhanced network and "control lights" is checked. They have the latest firmware. Running S5. Link to comment Share on other sites More sharing options...
Mr. P Posted October 16, 2018 Share Posted October 16, 2018 8 minutes ago, Rusty said: I just received 4 - 50 watt floods and they won't play in sequence editor. These are the only props in the sequence. They work in HU. They are set up as dumb RGB running on enhanced network and "control lights" is checked. They have the latest firmware. Running S5. I am pretty sure they are smart and not dumb as they come with five channels and not three. When adding them to your sequence add them by "inserting Device." Link to comment Share on other sites More sharing options...
Rusty Posted October 16, 2018 Author Share Posted October 16, 2018 Pretty sure that's what I'm doing. I'm using the "Add a Light-O-Rama device(AC controller, Cosmic, Pixie, Pixcon, Flood, Etc)" tab. So it basically sets it up for me. Link to comment Share on other sites More sharing options...
Rusty Posted October 16, 2018 Author Share Posted October 16, 2018 Figured it out. Won't work at 1000k. Link to comment Share on other sites More sharing options...
k6ccc Posted October 16, 2018 Share Posted October 16, 2018 (edited) Correct - Only the Pixcon16 and Pixie controllers will run at 1000k speed. At least at this time... Edited October 16, 2018 by k6ccc Link to comment Share on other sites More sharing options...
Recommended Posts