Jump to content
Light-O-Rama Forums

Pixie Circuit Board Specs and Dimensions for a 3d Printer


racerc20

Recommended Posts

Anyone ever make a mounting board or case for the pixie 4 8 and 16 using a 3d printer.  Looking to mount it to an insulated plate before mounting it to the cases.  Any help greatly appreciated.

Carl

 

Link to comment
Share on other sites

4 hours ago, racerc20 said:

Anyone ever make a mounting board or case for the pixie 4 8 and 16 using a 3d printer.  Looking to mount it to an insulated plate before mounting it to the cases.  Any help greatly appreciated.

Carl

 

Carl- that’s a lot of work. I just went to Lowe’s and had them cut plexiglass cost was around 8-$15 depending on the size.

I enclosed 8 pixies total. I still have to enclose 4 more I am awaiting my stand offs- I ran out.

JR

Link to comment
Share on other sites

Thank you both.  I had the spec measurements. I just figured theres a growing world of 3d print people out there and if someone had designed a mount plate already id just buy one.  Now I have to go buy a 3D printer.  Lol.

Link to comment
Share on other sites

  • The topic was locked
Guest
This topic is now closed to further replies.
×
×
  • Create New...