Feeleyfam Posted December 14, 2017 Share Posted December 14, 2017 I have added back a second AC controller to my show this year to go along with some Pixie 8 controllers and DMX controller. I have edited all my sequences to reflect adding Unit 1 and its channels. I can control the lights through HU for all channels but for some reason when I play any sequence in SE none of the channels from Unit 1 are playing. I have not used this unit in two years but bought some more lights to add to my show. Any ideas? I know its something simple but just can't figure it out. I have verified the new channels in the sequences are Unit 1. Thanks! Link to comment Share on other sites More sharing options...
TheDucks Posted December 14, 2017 Share Posted December 14, 2017 More input What mode- speed network What generations are the individual controllers (and their FW level)? Link to comment Share on other sites More sharing options...
Feeleyfam Posted December 14, 2017 Author Share Posted December 14, 2017 I am running 1 LOR network at 500k Enhanced. My Unit 1 is a 16PC-G3 Ver 1.06 and Unit 2 is 16PC-G3 Ver 1.09. I also have a CMB24D Ver 1.05 and 2 Pixie 8 Ver 1.03. Link to comment Share on other sites More sharing options...
k6ccc Posted December 14, 2017 Share Posted December 14, 2017 Do you have the LOR control panel running (which in turn starts the Comm Listener)? Link to comment Share on other sites More sharing options...
Feeleyfam Posted December 14, 2017 Author Share Posted December 14, 2017 Comms Listener is running while my show is enabled. Link to comment Share on other sites More sharing options...
Little_b Posted December 16, 2017 Share Posted December 16, 2017 (edited) I may be wrong, but I'm pretty sure you need to update the firmware on unit 1 in order to run it on an enhanced network. I had to do the same. I went from v1.06 to v1.08 (1.09 wasn't out when I did it) and now they run. Edited December 16, 2017 by Little_b more info Link to comment Share on other sites More sharing options...
Feeleyfam Posted December 16, 2017 Author Share Posted December 16, 2017 That is exactly what made it work. I appreciate the help. Link to comment Share on other sites More sharing options...
Recommended Posts