Paul Meikle Posted December 11, 2017 Share Posted December 11, 2017 I cannot play a sequence on the pixie 16 Ver 1.03 have read and watched hours of vidieos Set unit id to O1 config I have smart pixels and set 100 pixels at 100 pixel logical resolution Test each string each pixel of 100 lights 1 after the other Use pixel cosole select unit id 1 (string 1) select pixie controller Push controller red on the 1st 8 pixels do not light up rest do select unit id 2 controller red on 50 pixels light up Select unit id 3 controller red on 8 pixels on unit id go off 50 pixels on #3 turn on Test sequence 16 channels string 1 plays to sequence but only on the 1st 5 pixels Iam using the latest pro version 4.3.26 software new to this and i am like dumb pixel need a bit of help have 2nd pixie 16 to get to once i get over the hurdle of number 1 Thanks Link to comment Share on other sites More sharing options...
dibblejr Posted December 11, 2017 Share Posted December 11, 2017 6 hours ago, Paul Meikle said: I cannot play a sequence on the pixie 16 Ver 1.03 have read and watched hours of vidieos Set unit id to O1 config I have smart pixels and set 100 pixels at 100 pixel logical resolution Test each string each pixel of 100 lights 1 after the other Use pixel cosole select unit id 1 (string 1) select pixie controller Push controller red on the 1st 8 pixels do not light up rest do select unit id 2 controller red on 50 pixels light up Select unit id 3 controller red on 8 pixels on unit id go off 50 pixels on #3 turn on Test sequence 16 channels string 1 plays to sequence but only on the 1st 5 pixels Iam using the latest pro version 4.3.26 software new to this and i am like dumb pixel need a bit of help have 2nd pixie 16 to get to once i get over the hurdle of number 1 Thanks PM me a tel # I will call you. I am currently working on display and free. JR Link to comment Share on other sites More sharing options...
TheDucks Posted December 11, 2017 Share Posted December 11, 2017 Paul (I use a pixie4 and this is how it works in HU) in the HU, you should use ID 1 (the base ID) for the whole board Then use the PORT pulldown to select the port you want to test. note Light mode is grey for 100px per port. I used chase to verify my strings (tick RGBW to see all colors per node) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now