TheDucks Posted October 17, 2017 Share Posted October 17, 2017 I have 2 Pixie4's (08, 0C) on a single LOR HS network. When I run the HU Refresh, one unit does not always respond correctly' The CAT5e cables verify on a VDV scout (and have been swapped out for tests) I have tried with and without termination at the Pixie end. Link to comment Share on other sites More sharing options...
k6ccc Posted October 17, 2017 Share Posted October 17, 2017 Don't get too worried about that. It's pretty common to have one or more devices not show up on a scan. As I understand it, the scan is a fairly low tech system. I have seen that many times. Link to comment Share on other sites More sharing options...
TheDucks Posted October 17, 2017 Author Share Posted October 17, 2017 11 minutes ago, k6ccc said: Don't get too worried about that. It's pretty common to have one or more devices not show up on a scan. As I understand it, the scan is a fairly low tech system. I have seen that many times. Thanks, I will stop chasing the Gremlins. I had thrown out some old CAT5 (no e) because of this. It worked for a while with 5e, so I figured the 5 was just too lossy Link to comment Share on other sites More sharing options...
Recommended Posts