Jump to content
Light-O-Rama Forums

Recommended Posts

So I thought I would pose this question in case someone else has seen this and can shine some light on it for me. I have a CTB08-D contoller that I cannot get to keep a start address no mater what I do. I have tried to set it in software and used the hardware switches and anytime it is power cycled it clears completely. Any got any suggestions?

Share this post


Link to post
Share on other sites
k6ccc    499

I have one of those (although it was replaced with a Gen-3 version in the spring sale of 2016 so I could use it on an enhanced LOR network).  I don't remember any issues with that, but it's been years since I had to set it up.  I'll dig it out this evening and play with it to refresh my memory and see what I can learn to be able to help you.

 

Share this post


Link to post
Share on other sites
On 8/19/2017 at 1:18 PM, k6ccc said:

I have one of those (although it was replaced with a Gen-3 version in the spring sale of 2016 so I could use it on an enhanced LOR network).  I don't remember any issues with that, but it's been years since I had to set it up.  I'll dig it out this evening and play with it to refresh my memory and see what I can learn to be able to help you.

 

 

Thanks! I would appreciate that very much! I suspect it to be an issue with the hex to bcd converter or the switches themselves but im really not 100% sure if that is the case or not. I may see what LOR experts at the help desk think too.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×