Jump to content
Light-O-Rama Forums
mlswayze

Pixie 8 running WS2811 and WS2810

Recommended Posts

Is it possible to have the Pixie 8 run both WS2801 as well as WS2811 at the same time?

If so, how can it be configured to do that?  Both led's will be running 5 volt.

I already have my tree constructed with WS2801 and I am adding a star on top which would be easier with WS2811  (less wire to deal with)

Any tips / Suggestions would be great!

Thanks!

Edited by mlswayze

Share this post


Link to post
Share on other sites

All pixels on the controller must be the same protocol or type. The pixel type is set in the card configuration for the entire card.

Share this post


Link to post
Share on other sites

Ok thanks for the quick reply.  I was afraid of that but I was hoping that I could "split" the card into 2 separate "controllers". 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×