Jump to content
Light-O-Rama Forums
Brad Schou

CCB arch half working

Recommended Posts

I have tried a number of times to configure and run my one strand LOR CCB 100 bulb controller as an arch.  My controller in middle of the two 50 light strands connected correctly. I have updated firmware, set unit ID, all with no issues.  Tested in Hardware Util. and can make all 100 bulbs light up.

Once I go into SuperStar Squec editor, run an instant sequence it shows a full arch.  I export to SE and run, set to control lights and only half of the lights work (only 150 channels export from SSE).  they do what was set up in SSE but only on one strand.  Is this a set up issue in SSE? or in the controller? how do I set up the SSE editor to export 300 channels?

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...