toddm1919 Posted September 27, 2016 Share Posted September 27, 2016 I have 3 CCR controllers that are not showing up in the hardware utility and have no status light on. I have others on the same network that are fine. All are getting power (green light on power supply). Will resetting the controller possibly fix it? Does this reset it to factory settings (ID 1, original firmware)? Or did the controller fail? Link to comment Share on other sites More sharing options...
morden11 Posted November 24, 2016 Share Posted November 24, 2016 Can you describe your setup? (Where are the controllers on your network relative to the rest of the daisy chain? Beginning, end, middle?) Link to comment Share on other sites More sharing options...
Recommended Posts