Jump to content
Light-O-Rama Forums
Dave76

Help Moving from one PC to another

Recommended Posts

Hope someone can help me. 

I picked up a laptop and attempted to move everything to the new laptop.  All the LOR software installed without issue.  However, when I start my visualization, and then play my sequence, the lights in the virtualization no longer blink.  I have tried everything, verifying paths, LOR unit and channel counts are all the same between each.  Anyone experience this and have any tips on how to overcome without having to rebuild my virtualization?

Many Thanks.

Dave

Share this post


Link to post
Share on other sites

Make sure under the Play option in sequence editor that control lights and control visualizer are checked.

Share this post


Link to post
Share on other sites
37 minutes ago, Dave76 said:

Hope someone can help me. 

I picked up a laptop and attempted to move everything to the new laptop.  All the LOR software installed without issue.  However, when I start my visualization, and then play my sequence, the lights in the virtualization no longer blink.  I have tried everything, verifying paths, LOR unit and channel counts are all the same between each.  Anyone experience this and have any tips on how to overcome without having to rebuild my virtualization?

Many Thanks.

Dave

It's always a good idea to make sure the comm listener is running also

Share this post


Link to post
Share on other sites
14 minutes ago, B.Y.R.G. said:

Make sure under the Play option in sequence editor that control lights and control visualizer are checked.

BYRG thank you!  The control visualizer was not checked.  Cheers to you.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

×
×
  • Create New...