Jump to content
Light-O-Rama Forums
Sign in to follow this  
StuartA

Circuit 1 in Animation Sequence

Recommended Posts

In the attaced animation sequence, Circuit 1 is programmed to come on and stay on. Circuit 2 is programmed to come on and stay on 4/10 seconds later. And so on through Circuit 13. Problem is the Circuit 1 does not come on.

The circuits are programmed to immediately do the sequence in reverse - starting with 13. In that case Circuit 1 does come on at the end.

Any suggestions?

 

Using Sequence Editor v3.10.12

Controller CTB16PC

MiniDirector

LOR 2 Tree Lights 2015 v2.las

Share this post


Link to post
Share on other sites

You have new channels at the bottom configured to the same controller.  Remove or change your controller number to anything but 2 in the channel configuration on these new channels.  If this doesn't work, check and see if channel 1 will turn on using the Hardware editor.  If it does not then it's most likely a bad triac.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×
×
  • Create New...