BobinFL Posted January 8, 2008 Share Posted January 8, 2008 Installed my new USB485B today...no problems. It set up as comm4. When I started the control panel and then hardware and located my controller the USB port for my cable modem froze! The system was so locked up I had to do a power off reset. Updated the latest drivers for the485B and installed them...same problem. In addition my USB mouse becomes VERY erratic. This begins as soon as I start the control panel softwareAny thoughts?Thanks, Link to comment Share on other sites More sharing options...
LightORamaDan Posted January 8, 2008 Share Posted January 8, 2008 Does this happen when the CAT5 cable is not plugged into the USB485B? If you can check, do you know what version of USB drivers are installed?ThanksDan Link to comment Share on other sites More sharing options...
Guest wbottomley Posted January 8, 2008 Share Posted January 8, 2008 And... do you have it connected through a USB hub? Link to comment Share on other sites More sharing options...
BobinFL Posted January 9, 2008 Author Share Posted January 9, 2008 The problem doews not occur when the USB485B is not connected. I used the driver that Dan provided a link for and all seems ok.Thanks for the help,Bob Link to comment Share on other sites More sharing options...
Recommended Posts