Jump to content
Light-O-Rama Forums
kdjz28

Simple Show Builder - There were no events found.

Recommended Posts

Merry Christmas, Y'all. Have been working on a lag problem with my new 12 CCR Tree. I have some sequences that I have loaded and played successfully using the LOR Simple Show Builder. Now, when trying to make a new SD Card, on a few I am getting the error message "There were no events found." Not sure what I did to mess this up, but am open to suggestions? Thanks in advance for your help. Will do another post on the lag challenge. 

Share this post


Link to post
Share on other sites

The "No events found" issue has been resolved. 

 

Simple Show Builder (SSB) only recognizes one network, I had gone to a second network (AUX A) for my 12 CCR Tree to address the lag problem. The shows I attempted to build with only CCR Tree files were defined to the AUX A network and not seen by SSB, thus "no events found."

 

Chasing the issue, I used the Hardware Utility (HU)  to build a show. HU allowed the second network to be used and set at 500K and enhanced. I was able to export the files from SuperStar using Intensity rather than Legacy, helping the lag issue. 

 

End results, show built successfully to the SD Card and runs great with no lag. Yeah! 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...