Jump to content
Light-O-Rama Forums
Sign in to follow this  
txfirecop

Need CCR Help

Recommended Posts

Just started to test my new CCR's and am running into a problem. Have the latest firmware 1.17 and have changed all components with the same result. When I am in the Hardware Utility and select test at 100%, only about 10 pixel's are on with the last one a light green color. I reset the controller and the ribbon test just fine. I also tried an animation sequence with no ribbon response at all. I ran it through the verifier and get this message: Old MC-P compatibility enabled Message 44. Any suggestions? 

Share this post


Link to post
Share on other sites

Just tried my 2 yr old controller and all work as expected. Surely the three new controllers I just tried are not defective. Hopefully its a setting.

Share this post


Link to post
Share on other sites

Finally figured it out. Stupid mistake and huge brain fart!

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...