Jump to content
Light-O-Rama Forums
Sign in to follow this  
frankmbye

½ of my CCR tree does not work

Recommended Posts

½ of my CCR tree does not work. I’ve check with the hardware Utility and it shows Com. 4 with the first 6 channels with a network of regular and com. 5 with the last 6 channels with a network of Aux. A. When I try to play a sequence only the first 6 channels work. The last 6 are not working. The first one of the last 6 channels has the top ½ lite all of the time, whether the sequence is playing or not. Now for the rest of the story. When I fired the system up in my garage before I set it up outside everything worked just fine.

Share this post


Link to post
Share on other sites

Ok, I found it; I forgot to set my network preference for Aux. A. The tree works now, but I still have ½ of string #7 with white lights on, (the top ½) I cannot get them off, as a song plays they remain white. Anybody have any ideas.

Share this post


Link to post
Share on other sites

Try.to reset the controller by turning off power why you hold the reset button down then keep holding the button down and switch back on the ribbon will run through red green blue till you let it go then it should be reset if that dose not work then you have a loose connection some where hope this helps you out

Share this post


Link to post
Share on other sites

I had issues with my single CCR this year when I first set up. The HWU would see it, but I couldn't command the CCR...no led's would turn on. It was a flaky CAT5 connection on the regular controller that feeds the CCR controller. I switched the CAT cable to the other port and it suddenly started working normally.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...