Jump to content
Light-O-Rama Forums

DMX Questions


Discotech24

Recommended Posts

I am trying to use some of the Macros built in to the CMB controller but can't seem to get hem to work....I can get it to work in the hardware utility but how do I program my channels in the sequence to do the same thing......hardware utility uses 0-100 slider but when I use DMX edit in sequencing software it gives number values up to 255. HELP! Halloween is getting close. Thanks

Link to comment
Share on other sites

Macros?  The CMB DC controller cards don't have built in macros.  Maybe you are referring to something else.  Can you explain exactly what you are trying to do.

Link to comment
Share on other sites

Using your hardware utility, connect one CCB and see if it's configured properly and has the Macro Channels enabled.

They might be turned off.

 

Also, the HU can do either 0-100% or 0-255; check the option box on the bottom.

  • Like 1
Link to comment
Share on other sites

Checked Config and it is set for both Macro and RGB. Thanks for tip about 0-100 or 0-255, never noticed before.

Link to comment
Share on other sites

Checked Config and it is set for both Macro and RGB. Thanks for tip about 0-100 or 0-255, never noticed before.

 

See the CCB manual and use the Hardware Utility to access the last ten channels, which are the macro channels.

 

Playing with those should get you what you want.

Link to comment
Share on other sites

  • The topic was locked
Guest
This topic is now closed to further replies.
×
×
  • Create New...