Jump to content
Light-O-Rama Forums

Adding A Servo Dog


Big_Al

Recommended Posts

I am going to be adding the Servo Dog controller along with my LOR controller this year and want both to work during the same sequence. I do not see how to bring both up simultaneously in the same sequence. I am sure this is done all the time but it is not obvious how it is done to me. Any help would be appreciated.

Thanks

Big Al

Orlando

Link to comment
Share on other sites

Servo dog channels are just LOR channels. Be sure your SD has a different unit ID than your other controllers, and add channels with the appropriate config.

Link to comment
Share on other sites

  • 6 months later...

Is it really that simple to set up a servo dog? I figured it would have been a lot more complex then that. Maybe I'll have to consider making some servo props this year  :)

Link to comment
Share on other sites

  • 7 months later...

I have tried using the SD in the sequencer, however nothing happens unless I use the DIO32 device for the servo dog.  My servo dog also turns off, and does not reset until I unplug the servos.  What is confusing, is the servo dog utility works fine with my servo dog board.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...