Jump to content
Light-O-Rama Forums
Sign in to follow this  
robo

Can V1 controllers be connected with usb485 adapters?

Recommended Posts

I have 2 new controllers that run with the usb485. I just got 2 V1 controllers that aren't being detected? When I press auto config I get a pop-up that says "connect the SC485 serial connector to the serial port that you plan to use". I've been using the usb485 for my 2 new controllers. The status light is a steady red. Is there a setting or something that needs to be done to connect the V1 controllers using the usb485? I need to test these out asap since I just bought them used and want to verify that they work. Thanks Rob

Share this post


Link to post
Share on other sites

The controllers may be set with an address higher than you have the hardware utility set to look for. Try setting the hardware utility to look for the highest number that you can.

Share this post


Link to post
Share on other sites

Scott you are Da Man!!! Thanks so much. It was detected and now I'll try out the channels!! :]

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...