robo Posted June 16, 2012 Share Posted June 16, 2012 I have 2 new controllers that run with the usb485. I just got 2 V1 controllers that aren't being detected? When I press auto config I get a pop-up that says "connect the SC485 serial connector to the serial port that you plan to use". I've been using the usb485 for my 2 new controllers. The status light is a steady red. Is there a setting or something that needs to be done to connect the V1 controllers using the usb485? I need to test these out asap since I just bought them used and want to verify that they work. Thanks Rob Link to comment Share on other sites More sharing options...
Scott Cockroft Posted June 16, 2012 Share Posted June 16, 2012 The controllers may be set with an address higher than you have the hardware utility set to look for. Try setting the hardware utility to look for the highest number that you can. Link to comment Share on other sites More sharing options...
robo Posted June 16, 2012 Author Share Posted June 16, 2012 Scott you are Da Man!!! Thanks so much. It was detected and now I'll try out the channels!! :] Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now