Jump to content
Light-O-Rama Forums

JeffreyJMoore

Members
  • Content count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About JeffreyJMoore

  • Rank
    New Forum User
  1. Starting RGB Power Supply Before LOR Show- How To?

    Thanks to all those who replied to my call for help. Last weekend I had a chance to, for the first time, hook all the stars to the power supply and check out the operation of the programming, power supply and stars. I must say, I'm now hooked on RGB lighting, maybe not to replace all my incandescent mini lights but certainly to complement them. I sat in a dark garage watching the whole hour of programmed color fades and was pleasantly suprised by the by un-programmed colors created between color fades. Anyway, I also hooked up a Kill-a-watt and measured the power during full on and idle. I have decided to leave the power supply on all the time because the idle power draw is just 5 watts. Thanks again to all those who replied. Jeff.
  2. Greetings, I have been using a LOR animation sequence for a number of years that is an hour long and then loops back to the beginning and repeats for the entire evening. I use the Schedule Editor to start and stop the sequence that runs for a number of hours. This year I have added a number of Holiday Coro RGB stars to my display. I have assembled a solid state relay control for the 12vdc RGB power supply to allow LOR on/off power supply control. I would like to turn the RGB power supply on a minute or so before the LOR animation sequence starts. I have thought about a separate plug-in wall timer, but with all the high tech LOR control, that option seems clunky. As far as I can tell a background LOR sequence for just the power supply starts at the same time as the animation sequence. Will the Schedule Editor start two separate shows, one for the animation sequence and one for the power supply, at nearly the same time? Is there something better that I have not thought of? Many Thanks.
  3. Split Auto Startup Supply from Triac Supply in LOR1602W

    The sequence lasts for 1 hour then loops. The timer allows the sequence to run for the evening then shuts off. When the controller receives power the next night the show starts over again until the timer shuts off. I’m not using a computer to run the show, the show loaded on the first controller and starts when the timer sends power to it. I have the controller set to start the sequence upon power up.
  4. My display which consists of many slow fades that are looped uses the first of 3 controllers to hold and start at power-up the stored sequence. In years past with only 2 controllers I used a 4 pole contactor to apply power to all four controller circuits at once. Now this year with 3 controllers and 6 controller circuits I no longer can remove power from all controllers at once. My question has two parts: first, when power is removed from the first controller that has the sequence saved in it, will the other controllers shut down and not turn on any connected lights even though they are still plugged in and powered? Second: Is it possible to split the power that supplies the sequence running electronics from the high current triac electronics in the first controller? If I can split the two sections I can run the sequence electronics with a low power timer, leave the high power electronics plugged in all the time and not worry about adding additional poles to my contactor. Thanks to anyone who can help with my most recent display expansion.
×