Jump to content
Light-O-Rama Forums

Hgrave

Members
  • Content count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Hgrave

  • Rank
    New Forum User

Profile Information

  • Gender
    Male
  • Location
    Birmingham Al
  • Occupation
    Pastor

More About Me

  • Interests
    .
  • How I learned about Light-O-Rama -
    Interner
  • Favorite Decorating Holiday?
    Christmas lights
  1. Pixcon 16 HELP

    I have a pixcon16 I used last year on a trial run with no problem. I plugged it in this year and it found the controller in network preference under find/configure Pixcon16. I checked the j3/j4 box because I was going to use it on LOR mode. Even swapped the jumpers to LOR mode. Couldn't ever get that to work so decided to go back to what I used last year with E1.31. I now cannot find the board at all in network preference or talk to the board. I have reset the jumpers on the J3/J4 port back to ESTA and reset the board to factory default on advice from LOR customer service. I am connected through a router that has settings of 192.168.0.1 subnet 255.255.255.0 my computer is set to 192.168.0.2 subnet 255.255.255.0 Pixcon should be 192.168.0.50 since it's been reset to factory default I have reset the pixcon16 to factory default and forced it to default IP but still get nothing. Currently green light is solid while the red status light is flashing slowly. I also only show a solid yellow light on the Ethernet port and nothing on the green Ethernet light which I'm not sure if that's normal or not. The manual doesn't give a chart for solid yellow and no green light for the ethernet port. I am running v4.3.18 on the LOR Suite Any help would be appreciated. This is my first year doing a full show and I am getting frustrated. Thanks Hunter
  2. Pixcon16 not showing up

    I have a pixcon16 I used last year on a trial run with no problem. I plugged it in this year and it found the controller in network preference under find/configure Pixcon16. I checked the j3/j4 box because I was going to use it on LOR mode. Even swapped the jumpers to LOR mode. Couldn't ever get that to work so decided to go back to what I used last year with E1.31. I now cannot find the board at all in network preference or talk to the board. I have reset the jumpers on the J3/J4 port back to ESTA I am connected through a router with the settings of 192.168.0.1 subnet 255.255.255.0 my computer is set to 192.168.0.2 subnet 255.255.255.0 Pixcon should be 192.168.0.50 since it's been reset to factory default I have reset the pixcon16 to factory default and forced it to default IP but still get nothing. Currently green light is solid while the red status light is flashing slowly. I also only show a solid yellow light on the Ethernet port and nothing on the green Ethernet light which I'm not sure if that's normal or not. The manual doesn't give a chart for solid yellow and no green light. I am running v4.3.18 on the LOR Suite Any help would be appreciated. This is my first year doing a full show and I am getting frustrated. Thanks Hunter
×