Jump to content
Light-O-Rama Forums

nyemaster

Members
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

About nyemaster

  • Rank
    New Forum User

Profile Information

  • Gender
    Male
  • Location
    Killeen, TX
  • Occupation
    Software Engineer

More About Me

  • Interests
    Computers, Electronics, Flying and riding my Harley
  • How I learned about Light-O-Rama -
    Been using for a few years now, don't remember.
  • Favorite Decorating Holiday?
    Halloween
  1. I have 2 CTB16K kits I built. One of which works perfectly and the other cannot be identified by the LOR hrdware utility V4.1.2 The LED on the board just flashes and when queried by the hardware utility, just times out. I have removed the circuit board and looked at all my solder connections, and was sure all the parts are installed correctly in their respective places. I did solder in R1 (Resistor Network) backwards and realized this just as I was finishing the last solder point. So I cut the resistor out, de-soldered all the pins and cleaned the connections. I reordered the replacement part from Digi Key, and got it in a few days later. The numbers were verified and the new component was soldered in correctly. After I finished the PC board, I could never get it to function. I am sure the USB to serial connection is OK, as the other kit I put together works perfectly. I'd like to know which electronics on this card I should check. Obviously from the NIC connector back to what? Since there are no schematics, troubleshooting seems quite difficult. Worse case scenario is to have LOR look at he board and possibly fix it. Any idea of what I should do?
×
×
  • Create New...