Jump to content
Light-O-Rama Forums

rodneymanuel

Members
  • Content Count

    2
  • Joined

  • Last visited

Everything posted by rodneymanuel

  1. I can get all of my sequences to run in the sequence editor fine. Controllers respond fine as does the alphapix 16 for the CCRs. I close the sequence editor and open the control panel, which gives me a red light bulb in the task bar. When I right click on the red light bulb, and attempt to click on enable schedule, I get an error stating: "Show cannot be enabled because the comm port is already open. If the light o rama Hardware utility is running, shut it down and then enable shows." I do not have the hardware utility open nor do I have the sequence editor open. Any help would be greatly appreciated. Thanks in advance. Rodney
×
×
  • Create New...