i recently purchased a ctb16dv6 blue board kit and everything was going smoothly until i went to test the controller. After it did not function correctly i realized that i put in a resistor network in backwards. I can not seem to get it desoldered. I gave tried desoldering wick and desoldering pumps with no luck. I got the surface solder off but the solder down on the board i just could not get. After a while i thought i had removed enough solder to pull it out. long story short i got the component out but the pins are broken off inside the pcb. I need suggestions on how to get them out because i still can not get them out of the small holes on the PCB. P.S i do not want to use the banging or blowing method.