Jump to content
Light-O-Rama Forums

Pixie 8 running WS2811 and WS2810


mlswayze

Recommended Posts

Is it possible to have the Pixie 8 run both WS2801 as well as WS2811 at the same time?

If so, how can it be configured to do that?  Both led's will be running 5 volt.

I already have my tree constructed with WS2801 and I am adding a star on top which would be easier with WS2811  (less wire to deal with)

Any tips / Suggestions would be great!

Thanks!

Edited by mlswayze
Link to comment
Share on other sites

All pixels on the controller must be the same protocol or type. The pixel type is set in the card configuration for the entire card.

Link to comment
Share on other sites

Ok thanks for the quick reply.  I was afraid of that but I was hoping that I could "split" the card into 2 separate "controllers". 

Link to comment
Share on other sites

  • The topic was locked
Guest
This topic is now closed to further replies.
×
×
  • Create New...