mlswayze Posted June 25, 2017 Share Posted June 25, 2017 (edited) Is it possible to have the Pixie 8 run both WS2801 as well as WS2811 at the same time? If so, how can it be configured to do that? Both led's will be running 5 volt. I already have my tree constructed with WS2801 and I am adding a star on top which would be easier with WS2811 (less wire to deal with) Any tips / Suggestions would be great! Thanks! Edited June 25, 2017 by mlswayze Link to comment Share on other sites More sharing options...
mlswayze Posted June 25, 2017 Author Share Posted June 25, 2017 OOPS! I ment to say WS2801 in the subject line!! Link to comment Share on other sites More sharing options...
Mr. P Posted June 25, 2017 Share Posted June 25, 2017 All pixels on the controller must be the same protocol or type. The pixel type is set in the card configuration for the entire card. Link to comment Share on other sites More sharing options...
mlswayze Posted June 25, 2017 Author Share Posted June 25, 2017 Ok thanks for the quick reply. I was afraid of that but I was hoping that I could "split" the card into 2 separate "controllers". Link to comment Share on other sites More sharing options...
Recommended Posts