Dcroc Posted April 27, 2017 Share Posted April 27, 2017 (edited) I ordered the HC 16 strip pixel tree. My issue is that it will be 17' tall, and I have no ladder to get me to the top. Has anyone tried using this with strips? http://www.holidaycoro.com/Pixel-Strip-MegaTree-Topper-p/750.htm I was thinking about attaching the strips to pixel node strips http://www.holidaycoro.com/PixNode-Pixel-Mounting-Strips-p/767.htm . Thinking I could mount the topper, and strips, and then erect it without worrying about getting to the top after. However, I am worried about what the spacing my look like at the top? Any ideas? Am I over thinking this? Edited April 27, 2017 by Dcroc Link to comment Share on other sites More sharing options...
Light junky Posted April 28, 2017 Share Posted April 28, 2017 I ordered the HC 16 strip pixel tree. My issue is that it will be 17' tall, and I have no ladder to get me to the top. Has anyone tried using this with strips?http://www.holidaycoro.com/Pixel-Strip-MegaTree-Topper-p/750.htm I was thinking about attaching the strips to pixel node strips http://www.holidaycoro.com/PixNode-Pixel-Mounting-Strips-p/767.htm . Thinking I could mount the topper, and strips, and then erect it without worrying about getting to the top after. However, I am worried about what the spacing my look like at the top? Any ideas? Am I over thinking this?Drill whole bigger where the pole goes in and then put a pulley at the top of the pole with all the strands on and pull it all up all at onceSent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts