Jump to content
Light-O-Rama Forums

Can't enter simulation mode: Time is running backwards


Lighted Christmas Balls

Recommended Posts

I just started getting this error when trying to use the visualizer, which had worked fine for months. I am running v4.3.18 standard. I have rebooted several times, with no change. I saw some previous posts from 2015 here on this issue, but nothing recent. Help!

 

Sent from my SM-N910V using Tapatalk

 

 

Link to comment
Share on other sites

Read the When is a reboot not a reboot section Below..... Also check your clock is correct. May be a dead CMOS battery

 

Link to comment
Share on other sites

I did check the clock and it is correct

Sent from my SM-N910V using Tapatalk

Link to comment
Share on other sites

Do a restart...NOT a power off/on. Powering off/on does not reset the internals. It saves the settings for the next power on cycle.  Once you restart is resets the settings. The backwards time thing will happen if you haven't done this in a while

Link to comment
Share on other sites

Ok thanks I'll give that a try

Sent from my SM-N910V using Tapatalk

Link to comment
Share on other sites

That was the ticket, restart fixed it, thanks so much for the advice. It's my first year setting up a light show so I have a lot to learn

Sent from my SM-N910V using Tapatalk

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...