Casey Mulder Posted December 24, 2016 Share Posted December 24, 2016 Just got all the lights and controllers set up today. (yes, I procrastinate!) I can control the lights just fine with the Hardware Utility, but when I play the sequence in Sequence Editor, no lights come on. I checked all units and channels seem to be configured correctly. I checked that "Control Lights" is clicked on in Editor. I made sure I closed Hardware Utility before playing. Anybody have any clues what I should look for? Thanks! Link to comment Share on other sites More sharing options...
Don Posted December 24, 2016 Share Posted December 24, 2016 Did you remember to register the software? A demo version will act 'normal' but won't control the lights. Link to comment Share on other sites More sharing options...
Casey Mulder Posted December 24, 2016 Author Share Posted December 24, 2016 Hi Don, Thanks for the fast response! I'm pretty sure I registered when I bought the package. (i"ll have to double check) Thanks Casey Link to comment Share on other sites More sharing options...
Casey Mulder Posted December 24, 2016 Author Share Posted December 24, 2016 Yep, I can see my licence Number. Link to comment Share on other sites More sharing options...
Don Posted December 24, 2016 Share Posted December 24, 2016 When you have the Sequence Editor (And only the SE) open, what color is the box at the bottom right of the SE? (Very, very bottom) Link to comment Share on other sites More sharing options...
Casey Mulder Posted December 24, 2016 Author Share Posted December 24, 2016 Blue Link to comment Share on other sites More sharing options...
Don Posted December 24, 2016 Share Posted December 24, 2016 Based on what I've read, I would wonder if you properly set the address of the controllers and/or the controllers/circuits in the sequence. That blue box means you have communication with the controller. If you have Control Lights checked, then I'd be making sure the sequence or controllers is configured correctly. Link to comment Share on other sites More sharing options...
Casey Mulder Posted December 24, 2016 Author Share Posted December 24, 2016 I'm using 2 controllers Unit 1 and Unit 2. Each light strand responds correctly in Hardware Utility per its channel. I just restarted everything and am going outside to check it again. Link to comment Share on other sites More sharing options...
Don Posted December 24, 2016 Share Posted December 24, 2016 Take a look at that image. You have a few duplicate channels. I would suggest running the LOR Verifier (LOR Control Panel -> LOR Verifier) and see if the sequence has errors. Link to comment Share on other sites More sharing options...
Casey Mulder Posted December 24, 2016 Author Share Posted December 24, 2016 The reboot/restart of everything worked! Beautiful! The duplicated channel is because I was too lazy to separate the upper and lower eaves. Appreciate the assistance! Merry Christmas Link to comment Share on other sites More sharing options...
Don Posted December 24, 2016 Share Posted December 24, 2016 Take the duplicate out of there. It will cause problems later on. Good to hear everything is working now. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now