Brad Schou Posted December 17, 2016 Share Posted December 17, 2016 I have tried a number of times to configure and run my one strand LOR CCB 100 bulb controller as an arch. My controller in middle of the two 50 light strands connected correctly. I have updated firmware, set unit ID, all with no issues. Tested in Hardware Util. and can make all 100 bulbs light up. Once I go into SuperStar Squec editor, run an instant sequence it shows a full arch. I export to SE and run, set to control lights and only half of the lights work (only 150 channels export from SSE). they do what was set up in SSE but only on one strand. Is this a set up issue in SSE? or in the controller? how do I set up the SSE editor to export 300 channels? Link to comment Share on other sites More sharing options...
Recommended Posts